Description
This programmable card is intended to be used as « motherboard » in any ECU PnP project. Its reduced size (100x60mm) allows its integration into a multitude of original cases, or universal cases.
More complete than CoreF4, it can be linked with wire or on a PCB custom, a task facilitated by the provision of the symbol and the footprint (Kicad8), as well as several useful documents in the section « downloads ». its firmware based on Speeduino, features easy setting features such as selecting functions on its input and output pins. The setting can be done via TunerStudio or EpicTuner.
The built-in STM32F405RGT6 processor (168MHz) ensures high computing speed even at very high speeds. the 6-cylinder full sequential is possible, we also have room to drive a v8 in sequential injection.
On the SmartBoard there is a dual signal conditioner, a broadband module, the canbus transceiver, a BARO, a MAP (4bars) and several raw spindles programmable according to the needs of the project.
Pinout de la SmartBoard:
- 10 HC brooches (mass control) 10A max
- 6 Ignition brushes (positive signals to smart coils or ignition module, or others, switchable in pairs in 5-12v, without limiting resistance)
- 2 VR sensor inputs or hall
- USB direct output and UART, canbus and SecondSerial UART
- 6 Bosch LSU 4.9 (wide band)
- Supported common sensors: BAT, BARO, MAP, O2 internal card, CLT inputs, IAT, Oil temperature (TS gauge only) + 4 additional switches and 5 ADCs.
- VSS (vehicle speed) and Flexfuel inputs
- 7 raw spindles (I/O direct processor) with 5 in ADC 0-3v3 or PWM
- 12v power supply, 5v and 3v3 output for 1A MAX
Production times: 3-4 weeks.
Announcements
There's no opinion yet.