CoreF4_Boxed

Description

This complete universal mini ECU based on CoreF4 (my alternative version of the Core4 of DIYEFI) embarks everything necessary to run a basic/intermediate project. it is able to manage a 4 cylinders in sequential full, with no speed limit thanks to the performance of its STM32F4 processor.

It also has a signal conditioner for inductive sensors and a hall entrance 5-12v for phase.

The LSU 4.9 broadband is directly connected to the main connector thanks to the integrated management module.

Connectivity is not forgotten, with its easily accessible USB C port, its built-in Bluetooth module and the ability to take out the SecondSerial and Canbus internal pins.

All in a box printed in France in ASA-CF, encapsulated silicone anti-humidity, anti vibration and favoring thermal dissipation. There are two lids available, translucent or opaque PCB way with Pinout on the back.

Dimensions ECU: 110x60x38mm, 90mm wide with fastening eyelets, 135mm long with connected beam connector.

ECU pinout (SuperSeal 34pin connector supplied):

• 9 HC brooches (mass control) 6A max (Injector 1 2 3 4, FAN, FUEL, IDLE, VVT, BOOST)
• 4 Ignition brushes 1 2 3 4 (positive signals to smart coils or ignition module)
• 6 Brooches LSU 4.9 Bosch
• Common sensors (IAT, CLT, GST, Launch, VR1+/Hall 5-12v 1, VR1-, Hall 5-12v 2)
• 12v power supply and 5v output sensors
• 4 pins « Custom »

The pins « Custom » are 4 pins that I can set when mounting to best stick to the project configuration. have, to choose:

• Canbus exit (2 Broches)
• Output SecondSerial (2 Broches)
• Flexfuel
• Additional switch
• 2 Additional CDAs
• External MAP (Internal MAP output will not be present on ECU)
• Tacho

For the choice of the cover, the selection of the ignition voltage, the selection of Custom pins or if you need to reallocate pins to other spots, don't forget to specify your wishes when ordering.

By default, the ignition will be in 5v, the lid will be random and the Custom pinout will be Flexfuel, Sup. switch, Sup. ADC, Tacho.

Customization of the PCB lid possible (colour, professional logo or club, for example)

Production times: 3-4 weeks.